ஜியோலஜி & ஜியோபிசிக்ஸ் ஜர்னல்
திறந்த அணுகல்

சுருக்கம்

Modelling the Development of Oil Rim Using Water and Gas Injection

Miel Hofmann*, Sudad H AL-Obaidi, WJ Chang

Using water injection or gas injection, this study examines the effectiveness of technologies for developing oil rims on gas fields. Considering the need for advanced development of the oil rims within a short period of time, reservoir simulation methods using horizontal wells have been used to rationally develop oil rims. It was confirmed that large volumes of gas must be injected to maximize oil recovery. This happens when gas breakthroughs from the gas cap into the bottom of the production well and from the injection well into the gas section. A cycle process was discovered when gas injection led to the development of an oil rim. The condensate from the gas was taken out, and the dryer gas was then injected back into the reservoir. Condensate concentrations in the gas, especially those near the oil rim, are a major factor contributing to the interest in the proposed concept.