இரசாயன பொறியியல் மற்றும் செயல்முறை தொழில்நுட்ப இதழ்
திறந்த அணுகல்
ஐ.எஸ்.எஸ்.என்: 2157-7048
ஐ.எஸ்.எஸ்.என்: 2157-7048
Abdukarem Amhamed and Ahmed Abotaleb
In hot regions like the Middle East, the road asphalt pavement experience many fluctuations in their temperature profile that provides the large dark surface area with intensive heat absorption capacity, which warms the roads up to 75°C or more in summer. This phenomenon is negatively affecting the performance and urban heating. On the other hand, the most amount of water available (about 97%) is low-quality water or seawater, which needs to be treated in an efficient way to cope with the dramatic increase on demand of clean water due to population growth and agriculture requirements. Several techniques have been used for water desalination and most are thermally based techniques. Therefore, they are consuming high energy per water desalinating volume. The aim of this study is to design a novel heat harvesting system combined with a membrane based unit, to produce clean water from impure water. The heat will be harvested from the roads and buildings, by a low-grade system through Forward Osmosis (FO) unit. The diluted draw solution (SD) will be regenerated at low operating temperature, while the road and building’s roofs surfaces are cooled and maintained at a lower temperature. The proposed technology will save energy and enhance microclimate conditions as well. The innovative DS regeneration system was simulated by HYSYS V8.8 and the results show a 1.17 m3 /hr of treated water can be recovered for each one-m2. The quality of water depends on the amount of heat harvested and, consequently the surface temperature. Potable water is achievable only when the surface temperature is higher than 70°C and, therefore a trim heater is recommended for the winter season otherwise, the water will be used for non-drinking applications. Although the required Capex for this technology is around $13778/m2, but the payback is two years.